Inicio
wii hdmi
Wii to HDMI Video Output Converter - Supports All Wii Display Modes – Retro Game Repair Shop

Wii to HDMI Video Output Converter - Supports All Wii Display Modes – Retro Game Repair Shop

5 (478) · € 3.50 · En stock

Supports all Wii display modes (NTSC 480i 480p, PAL 576i)

Attention: it can't be connected to the switch/splitter, only connect directly to the TV, monitor, projector

Don't forget to go in the settings and change screen resolution from 480i to 480p. Some HDTVs do not support games at 240p/480i over HDMI: they only work through the composite A/V cords. If you switch the Wii to 480p mode they may work over HDMI

This device plugs into the A/V port on the back of the Wii.
The device taps into the component video output of the A/V port, which is the highest quality the Wii outputs.
The device performs an analog-to-digital conversion and outputs the digital signal via HDMI, 720x480@60Hz (EDTV 480p).
The analog stereo audio is converted to Linear-PCM 16-bit 48KHz, which is very high-quality and compatible.
The digital audio/video signal is sent over a connected HDMI cable to a monitor or television.

After setting up the device, make sure to enter your Wii Settings and change the aspect ratio (Widescreen Settings) to 16:9 (if using a widescreen display or an HDTV), the Resolution to 480p (EDTV) (if your display supports this, all HDTVs do), and the Surround Sound Settings to Surround (Dolby Pro Logic II) for the best video and audio quality. Adjust your television to stretch the newly configured widescreen video across the screen (if using a widescreen display). Finally, if using a surround sound system, engage Dolby Pro Logic II decoding for surround effect in supported games.