• Inicio
• shelly 1
• WLED on Shelly 1 - Hardware - WLED

WLED on Shelly 1 - Hardware - WLED

4.6 (302) · € 23.00 · En stock

Hi, has anyone tried to flash the Shelly 1 with WLED and use it as a controller? I would like to use it as a controller for a 12V Stripe, because I can feed it directly with 12V. Here is the information I found about the PIN-Out: I had planned to connect the data line via the SW terminal (GPIO 5) with a resistor to the Shelly. I mean somewhere times have read that this has already been implemented, I find the contribution unfortunately no longer. Greetings Freund der Nacht

WLED on Shelly 1 - Hardware - WLED

LED strip controller with wall switch. Working fallback without HA - Hardware - Home Assistant Community

Ready to go controller for WS2812B powered by WLED and type-C connector. Pre-flashed.

Pixel (addressable) WLED controller A1-SLWF-02 LED

10 Minute LED Lights For Any Holiday With WLED - HomeTechHacker

Shelly 1 SW pin (GPIO5) does not work correctly · Issue #2494 · Aircoookie/ WLED · GitHub

Other Hardware - WLED MoonModules Project

WLED shield board for addressable LEDs from Shields and more on Tindie

CORRUPT HEAP with 0.14.1-b2, ESP32, maybe related to MQTT · Issue #3637 · Aircoookie/WLED · GitHub

Compatible controllers - WLED Project